Joan P. Door County Peninsula
Thanks again, Jerry, for the good work your crew does! Have a safe and healthy winter. Talk to you as we approach spring.
Best Regards,
Joan P.
Thanks again, Jerry, for the good work your crew does! Have a safe and healthy winter. Talk to you as we approach spring.
Best Regards,
Joan P.
Thanks Jerry. We’re thrilled with the job that your team did! Tony was great to work with….
Go Pack Go!
Kay J
Response – Thank you. We appreciate your comments and look forward to next year.
Jerry & Dave,
Thank you again for great work at Arbor Cottage. Much appreciated!! Have a great rest of the year.
Brad R. Door County
Response – Thank you for your note. We will let our crew know. They always appreciate it.
Vinyl bunks are a much better value than carpeted bunks. You bought your boat to enjoy yourself – not replace worn-out carpeting on the weekend.
Many boat and PWC lifts utilize carpeted bunks to support the vessel. These are an economical option and provide sufficient support for your boat or PWC (personal watercraft).
However, over time, the carpet on wood bunks becomes worn or frayed. This situation can create contact between the hull of the boat and the raw wood. Besides, sand and debris could be lodged in the carpet fabric. The sand will grind against the hull of the watercraft. It goes without saying this is not a condition you want. Any loose or frayed carpet should be replaced to prevent potential trip hazards too.
Do your carpeted boat bunks need replacement again this year? Vinyl bunks never require replacement.
Vinyl boat bunks may cost more than carpeted bunks initially but they are a better value over time.
Spring & Fall are excellent times to inspect the wood structure of the carpeted wood bunks. Wood, being a natural material, can become warped, cracked, or rotten. If you find any soft spots or warping of the wood material, replace the bunk before using it.
For more information on checking & servicing your lift, see https://wisconsinpws.com/lift-cable-maintenance/
Perhaps you’ve purchased a new PWC or boat and want the best bunk for your new purchase, consider ShoreMaster vinyl boat bunks.
ShoreMaster has used vinyl boat bunks for boats, PWC’s and pontoons for decades. The vinyl bunks will save you money in the long run because the aluminum channel will never rot or warp like wood. Plus, the vinyl never requires replacement like carpeting does. You’ll also save money and frustration because the vinyl material is less prone to wear than carpet,
Put simply; vinyl boat bunks are far more durable than carpeted bunks. The vinyl material used on ShoreMaster‘s vinyl boat bunks does not promote the adhesion of sand, and debris like carpet can, which means your boat or PWC will stay cleaner, longer.
Full-length vinyl boat bunks offer greater support than cradles. A much longer area is supported. The weight of your watercraft is distributed along the bunk’s length to prevent pressure points where your hull contacts the supports. When you have a choice between cradles, carpeted bunks, and vinyl bunks, you are better off in the long run with the vinyl boat bunks. When it comes to the total cost of ownership and resale value, vinyl boat bunks are the best value.
Vinyl boat bunks are available for all ShoreMaster boat lifts. If you are considering repairing a set of carpeted wood bunks, it may be wise to upgrade to vinyl bunks once and for all.
Pier & Waterfront Solutions (PWS) specializes in all ShoreMaster accessories for docks and lifts. We are located in the center of Door County at 7325 St Hwy 57 south of Sturgeon Bay at the intersection of Idlewild Road. Our staff looks forward to serving all of your waterfront needs.
The continued introduction of refinements keeps Shoremaster at the top of the best-in-class list.
Have friends or neighbors you believe should see this article? Email a link to this article – and Thank you!
You can visit Pier & Waterfront Solutions on Facebook also.
Pier & Waterfront Solutions has remained “open.”
While all this is going on, we are working to maintain the trusted service you expect. That’s important to us.
We are conducting as much business as possible by email, text, or phone. Site visits will continue as usual. When in-person contacts are necessary, we follow “social distancing” guidelines as closely as possible.
Call, message, or use this simple request form to get answers and quotes.
Thank you for allowing us to work with you – safely.
Stress – Even boat lifts are under stress – this year more than ever before due to the high waters.
We’ve previously informed you of the danger to boat lift cables during a storm. If the waves hit the bottom of your boat it will momentarily lift the boat and then allow it to fall back on the rack. What if the cables are weakened by rust and frays? The “bouncing” effect can completely sever a cable into two pieces.
How can that movement harm the cables?
Even though the boat only rises a fraction of an inch, the energy of the “falling” boat must be absorbed by the boat rack. The cables in each corner of the lift must, in turn, absorb the stress of a moving 3-5,000 pound boat.
Having said that, a weakened cable is in imminent danger of breaking. Think of an 80-100 lb jackhammer used to break up concrete. Even reinforced concrete can not withstand the movement of the bit hitting the concrete.
With a boat, you are talking about a potential 5,000 lb weight dropping on a rack compared to an 80-100 lb. weight.
Protect your cables! It only takes a minute or two to protect your cables from rust. It’s simple and easy to do. A convenient link* is provided below so you can learn more about this.
There are warning signs of defects in your cables? If your cables look like any of these, it’s time to replace them. Need more information? Here’s an article that addresses this issue.
Always remember – it is possible to have broken strands inside your cable without any exterior signs of damage. This situation is especially true on stainless steel cables which do not rust.
At the beginning of the year, we place your boat lift in the requested location. We adjust the height of the legs based on what the current water level is.
Unfortunately, the water has continued to rise this year and that may no longer be suitable for the conditions you have today. Add to this the Seiche waves (pronounced “say-sh”) which are standing waves that form in a confined body of water. The friction of the wind against the surface of the water causes wave action.
As waves move towards the shoreline the water gets shallower and the moving waves rise higher. Standing waves, in general, can form in any type of semi-enclosed or enclosed body of water. When these rising waves hit the bottom of your boat the boat does what it is designed to do – it floats on the water.
The lift rack could be too close to the water to protect your boat with the rising water. As a result, you are not able to raise the boat high enough to keep it above the waves. On the other hand, If the rack is set too high in the water, you may not be able to get your boat on the lift. It’s a delicate balance. The variable is the changing depth of the water.
One way to raise the boat higher is to purchase longer legs and replace the standard lengths with new ones.
A less costly alternative is to simply move your lift closer to shore. It will be in shallower water and save you having to buy longer legs and the labor to install them.
If you keep the standard legs and don’t allow us to place the lift closer to the shore, you are inviting costly repairs or even replacements.
Get out there and take care of those cables. Check out the link below. Then, consider moving the lift closer to shore.
Have friends or neighbors you believe should see this article? Email them a link to this article – and Thank you!
You can visit Pier & Waterfront Solutions on Facebook also.
Located at 7325 St. Hwy 57, we are about 3 miles south of Sturgeon Bay, and 1 mile past the intersection of Cty MM (heading north). Look for the intersection of Idlewild Road and Hwy 57.
Pier & Waterfront Solutions has remained “open.” We have implemented measures to ensure the safety of our employees and visitors. As of Aug 1st, Wisconsin mandates the use of face masks. We also endorse this to slow the spread of Covid-19. It’s the only known method to control the spread at this time.
While all this is going on, we are working to maintain the trusted service you expect. That’s important to us.
We are conducting as much business as possible by email, text, or phone. Site visits will continue as usual. When in-person contacts are necessary, we follow “social distancing” guidelines as closely as possible.
Our display yard is always open for you to examine at your leisure. All displays have a numbered, red tag on them. If you want more information or pricing, please reference that number.
We provide estimates and invoices by email to make the process paperless and faster. With these measures, we hope everyone will stay safe, and we will be back to normal operations soon.
Please conduct as much business as possible via emails, messaging, and emails. When you see our crews working in your area, please practice “social distancing.”
Call, message, or use this simple request form to get answers and quotes.
Thank you for allowing us to work with you – safely.